Steinbach Active Balls 50 - Before First Use; Pre-Start Up Checklist; Preparing the Filter Vessel

The mer now controls the running mes of the pump.
Filtering time
The pool's water content should be turned over at least three to ve mes in 24 hours
depending on the use and the size of the system. The operang me depends on the
output of the lter system and the pool size.
Operation with floor cleaners
Use a skimmer with a screen basket or similar device if your lter system
does not feature a prelter to prevent foreign objects from damaging the
device.
Observe the instrucon manual notes of the oor cleaner. Air must not
penetrate the lter system to prevent the system running dry and
overheang.
You can connect the hose of the oor cleaner
directly to the sucon line of the lter system.
The hose of the oor cleaner must be
completely lled with water.
Before First Use
Check the following before start-up
1. Make sure that the pump's power cable is disconnected from the power supply.
2. Make sure that the device is located outside the pool and below the water level.
3. Make sure that all feed and drain lines are correctly connected and fastened in place.
4. Make sure that the pool's water level is at least 2.5 to 5 cm above the opening of the
sucon line. If this is not the case, ll the pool.
Preparing the filter vessel
1. Remove the locking ring
2
by unscrewing the wing nut
5
counterclockwise.
2. Put aside the locking ring and its wing nut.
3. Screw the riser pipe
7
onto the screen
8
.
2
44