Fig. 39
3. Remove nuts from inside washer.
Fig. 40
4. Remove air gap.
Fig. 41
5. Disconnect hoses.
6. Reverse procedure to install.
NOTE: Make sure gasket is installed between inside
wall of tank and air gap. Replace gaskets as
necessary.
7. Check for proper operation.
DOOR SWITCH
NOTE: Door magnet is part of door.
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Place dishwasher in
CONTROL PANEL
SERVICE POSITION.
2. Remove left side panel.
3. Disconnect door switch from control board (J10).
4. Remove screw securing door switch.
Fig. 42
NOTE: Door switch magnet is located inside the door
and is not serviceable.
5. Reverse procedure to install.
NOTE: Add small amount of Permagum between
sensor and bracket.
NOTE: Verify sensor is not lose and rattling.
6. Check for proper operation.
7. Check for rattles.
SG, SU-L, SU-H DISHWASHERS - REMOVAL AND REPLACEMENT OF PARTS
Page 17 of 59 F45577 (1215)
To Next Page
Loading...
