STERO SG - 100 K OHM THERMISTOR TEST - RINSE PROBE (2 QTM)

3. Test the heater for resistance and compare
meter reading to
BOOSTER HEATER TEST
SPECIFICATIONS.
100K OHM THERMISTOR TEST - RINSE PROBE (2QTM)
1. Determine temperature of water.
2. Disconnect thermistor leads.
3. Determine resistance of thermistor.
4. Compare resistance to chart.
Thermistor Temperature /Resistance Chart
70°F = 120kΩ 130°F = 28kΩ 190°F = 8.2kΩ
80°F = 91kΩ 140°F = 22.5kΩ 200°F = 6.9kΩ
90°F = 72kΩ 150°F = 18kΩ 210°F = 5.8kΩ
100°F = 55kΩ 160°F = 14.5kΩ 250°F = 2.9kΩ
110°F = 44kΩ 170°F = 12kΩ 290°F = 1.6kΩ
120°F = 34.5kΩ 180°F = 10kΩ
SG, SU-L, SU-H DISHWASHERS - SERVICE PROCEDURES AND ADJUSTMENTS
Page 33 of 59 F45577 (1215)