After the wash cycle ends, water is drained from
the sump to allow for the rinse water from the
holding tank (cold machines) or booster (hot
machines).
POWER-DOWN / DRAIN
When the POWER key is pressed, the unit will
enter a drain cycle. Booster or holding tank will
be purged, and sump will be drained. After the
completion of the drain cycle, power to the
controls is removed under software control. At
this point, the control is inoperable until the
POWER key is pressed.
PROGRAMMING MENUS
There are 3 Programming Menus that can be
accessed when the Menu/Down Arrow button is
selected. Each menu has parameters that can be
changed that affects the way the dishwasher
operates. Each menu is protected by a 4 digit access
code.
Use the arrow keys to change the ( -> ) to the desired
number and press enter to move to the next digit.
NOTE: The Manager Programming menu uses 1001
as the access code. Just select enter to move to the
next digit.
•
MANAGER PROGRAMMING (1001)
• SOAP PROGRAMMING (7627)
•
SERVICE PROGRAMMING (8934)
SG, SU-L, SU-H DISHWASHERS - GENERAL
F45577 (1215) Page 6 of 59
To Next Page
Loading...
