STERO SG - PRIME PUMPS; EXIT MENU

EDIT PARAMETERS
Parameter
Name
Cold Units
(Stero SU-L)
(Stero Glass
Washer SG)
Hot Units
(Stero SU-H)
Description Possible Values Default Values
Sanitizer
Threshold
Stero SU-L
Stero SG
N/A
Sets detection
amount.
Sets maximum
allowable chemical
sense reading (mV)
for sanitizer.
500-4000 (by 100's) 1100
Exit Menu
Stero SU-L
Stero SG
Stero SU-H
Exits Edit
Parameters menu.
PRIME PUMPS
Parameter
Name
Cold Units
(Stero SU-L)
(Stero Glass
Washer SG)
Hot Units
(Stero SU-H)
Description Possible Values
Pump Menu
Stero SU-L
Stero SG
Manual prime for
sanitizer pump.
If chemical sensor
value is below set
threshold value,
priming stops.
Pump Menu
Sanitizer
NOTE: Default
setting shown
in bold.
1100mV
Range: 70 to 2900
mV
Stero SU-L
Stero SG
Stero SU-H
Manual prime for
detergent pump.
If chemical sensor
value is below set
threshold value,
priming stops.
Detergent
NOTE: Default
setting shown
in bold.
1100mV
70 to 2900 mV
Stero SU-L
Stero SG
Stero SU-H
Manual prime for rinse
aid pump.
If chemical sensor
value is below set
threshold value,
priming stops.
Rinse Aid
NOTE: Default
setting shown
in bold.
2500mV
70 to 2900 mV
Exit Menu
Stero SU-L
Stero SG
Stero SU-H
Press ENT to exit the
Prime Pumps Menu
and return to the Soap
Menu. Any settings
that were changed are
saved.
SG, SU-L, SU-H DISHWASHERS - SERVICE PROCEDURES AND ADJUSTMENTS
F45577 (1215) Page 26 of 59