Online version - not for reprint
40 MS 341, MS 361, MS 361 C
: Remove the sleeve and slip it
onto the other end of the shank.
Inner pin must again point toward
flat face.
VA
249RA148
: Apply the installing tool
(5910 890 2211) to the piston
boss, hold the piston steady,
center the tool shank exactly and
press home until the snap ring
slips into the groove.
VA
212RA081
Fit the snap rings so that their gaps
are on the piston's vertical axis (they
must point either up or down – see
arrow).
VA
249RA150
: Fit new cylinder gasket,
curvature facing down, on the
crankcase.
– Line up the piston rings – b 6.6
VA
212RA082
– Lubricate piston and piston rings
with oil.
: Rest the piston (1) on the
wooden assembly block (2)
1108 893 4800.
VA
212RA083
1
2
: Push the manifold (1) on to the
intake port, paying attention to
the correct installed position (see
arrow).
: Note installed position of the
clamp (2).
VA
212RA085
1
2
: Tighten down the clamp (1) so
that it closes against the spacer
sleeve (2).
On clamps with spacer sleeve,
tighten the screw until the gap “a”
between the two ends of the clamp
is 5 to 6 mm.
212RA283
VA
a
2
1
To Next Page
Loading...
