Online version - not for reprint
68 MS 341, MS 361, MS 361 C
: Pull the short circuit wire (1)
sideways from under the
retainer (2).
VA
212RA118
1
2
: Swing the short circuit wire up
and remove it sideways.
Installing
VA
212RA119
: Fit the short circuit wire (1) under
the retaining lug (arrow).
: Position the short circuit wire (1)
above the switch shaft.
VA
212RA120
1
: Lift contact spring (1) up and fit
the switch shaft (2) in the right-
hand mount (3).
212RA121
VA
1
32
: Push the switch shaft (1) into the
left-hand mount (2).
Reassemble all other parts in the
reverse sequence.
212RA311
VA
1
2
: Push the retainers (arrows) apart
(on the underside of the rear
handle).
– Remove the handle molding
upwards.
VA
212RA125
– Pull the throttle rod (1) sideways
out of the trigger.
VA
212RA127
1
– Move the Master Control to the
“RUN“ position.
: Remove the interlock lever (1).
VA
212RA126
1
10.2 Throttle Trigger /
Interlock Lever
10.2.1 Without QuickStop Super
To Next Page
Loading...
