Stihl MS 341

Online version - not for reprint
66 MS 341, MS 361, MS 361 C
– Remove the spring between the
front handle and cylinder –
b 9.1.1
– Remove the annular buffer
between the tank housing and
crankcase – b 9.1.2
VA
212RA110
1
2
– Remove the chain catcher –
b 5.2
: Carefully pry out the spring (1)
with bearing plug (2).
: Pry out the annular buffer (1).
VA
1
212RA111
: Use a suitable tool to unscrew the
spring (2) from the tank housing.
: Use a suitable tool to unscrew the
bearing plug (1) from the spring
(2).
: Pull off the annular buffer (3).
VA
2 3
212RA112
1
Reassemble in the reverse
sequence.
: Use a suitable tool to screw the
bearing plug (1) on to the spring
(2) as far as stop (arrow).
VA
212RA114
1
2
: Push the annular buffer (1) into
position (tapered end must face
the spring).
: Use a suitable tool to screw home
the spring (2) as far as stop
(arrow).
VA
212RA113
1
2
: Carefully fit the spring (1) with
bearing plug (2).
The bearing plug must be fully
recessed in the crankcase.
– Install the chain catcher – b 5.2
VA
212RA115
VA
1
2
Reassemble all other parts in the
reverse sequence.
9.1.3 Spring, Annular Buffer
between Crankcase and
Tank Housing