Online version - not for reprint
49MS 341, MS 361, MS 361 C
– Remove the shroud – b 6.2
– Unscrew the decompression
valve (1).
Install in the reverse sequence.
– Fit the decompression valve and
VA
212RA068
1
tighten it down firmly – b 3.5
Reassemble all other parts in the
reverse sequence.
Exercise extreme caution when
troubleshooting or carrying out
maintenance and repair work on the
ignition system. The high voltages
that occur can cause serious or
even fatal accidents.
Troubleshooting on the ignition
system should always begin at the
spark plug – b 4.4
The electronic ignition system
basically consists of an ignition
module (1) and flywheel (2).
VA
212RA224
2
1
The ignition module accommodates
all the components required to
control ignition timing. There are
two electrical connections on the
coil body:
: High voltage output (1) for
ignition lead
VA
212RA225
2
1
: Connector tag (2) for short
circuit wire
Testing in the workshop is limited to
a spark test.
A new ignition module must be
installed if no ignition spark is
obtained (after checking that wiring
and stop switch are in good
condition).
6.8 Decompression Valve 7. Ignition System 7.1 Ignition Module
To Next Page
Loading...
