Stihl MS 341

Online version - not for reprint
69MS 341, MS 361, MS 361 C
: Use a 5 mm drift to drive out the
pin (1).
: Remove the throttle trigger (2)
with torsion spring (3).
VA
212RA128
2
1
3
: Remove the torsion spring from
the throttle trigger.
Reassemble in the reverse
sequence.
VA
212RA129
: On machines with handle heating
the wires (1) from the heating
element must be in the guide
(arrow) under the interlock lever.
VA
212RA130
1
When installing, make sure the
torsion spring be under the interlock
lever and engage the notch (arrow).
VA
138RA128
: Press down the interlock
lever (1).
: Push the throttle trigger (2)
upwards and move the switch
lever (3) to “Choke“ position.
VA
212RA131
1
2
3
: Position the handle molding so
that the lugs engage the
recesses (arrow).
Reassemble all other parts in the
reverse sequence.
VA
212RA132
: Push the retainers (arrows) apart
(on the underside of the rear
handle).
– Remove the handle molding
upwards.
VA
212RA125
– Pull the throttle rod (1) sideways
out of the trigger.
VA
212RA152
1
: To remove the interlock lever (1),
use a 3 mm drift to drive out the
needle roller (2).
VA
212RA201
1 2
VA
10.2.2 With QuickStop Super