Online version - not for reprint
70 MS 341, MS 361, MS 361 C
: Use a 4.5 mm drift to drive the
bushing (1) out of the interlock
lever (2).
: Remove the torsion spring (3).
Reassemble in the reverse
sequence.
VA
212RA202
3
2 1
: To remove the switch lever (1), tilt
it back.
VA
212RA203
1
: Disconnect the brake cable (1)
from the switch lever (2).
– Use a 3 mm drift to drive out the
needle roller and then remove the
switch lever.
VA
148RA055
1
2
: Drive out the straight pin (3) with
a 5 mm drift.
: Remove the throttle trigger (2)
with torsion spring (1).
VA
148RA058
2
3
1
: Take the torsion spring (1) off the
throttle trigger.
Reassemble in the reverse
sequence.
212RA133
VA
1
: Lubricate bearing points (arrows)
with grease – b 16.
– When installing, make sure the
short leg (arrow) of the torsion
spring locates in the throttle
trigger. The long leg points
towards the carburetor.
VA
148RA047
: Position the handle molding so
that the lugs engage the
recesses (arrow).
Reassemble all other parts in the
reverse sequence.
VA
212RA132
To Next Page
Loading...
