Stihl MS 341 - Wiring Harness; Without Handle and Carburetor Heating; With Handle Heating System

Online version - not for reprint
100 MS 341, MS 361, MS 361 C
– Separate the crankcase from the
tank housing – b 12.9
– Remove the short circuit wire –
b 10.1
– Remove the ground wire – b 7.2
VA
212RA239
21
: Pry out the grommet (1).
: Pull out the wires (1).
Install in the reverse sequence.
On machines with
QuickStop Super
: Position the wires (arrows) under
the brake cable (1).
VA
212RA240
1
: Make sure the ground wire (1)
and short circuit wire (2) are
correctly positioned (see arrows).
212RA308
VA
1
2
Check correct installed position of
the grommet (arrows).
Install all other parts in the reverse
sequence.
VA
212RA241
– Separate the crankcase from the
tank housing – b 12.9
– Remove the short circuit wire –
b 10.1
– Remove the ground wire – b 7.2
VA
212RA244
1
2
– Remove the interlock lever –b
10.2.1 or 10.2.2
: Remove the wire (1) from the
guide (arrow).
: Push back the insulating tubes
(2) and separate the connectors.
: Pull the wires out of the insulating
tube (1).
– Pull the wire out of the opening in
the tank in direction of front
handle.
VA
212RA245
1
14.8 Wiring Harness
14.8.1 Without Handle and
Carburetor Heating
14.8.2 With Handle Heating
System