Stihl MS 341

Online version - not for reprint
54 MS 341, MS 361, MS 361 C
– Remove the puller from the
flywheel.
: Pull off the flywheel.
Inspect flywheel and magnet poles
for cracks or other damage. If you
find any damage, install a new
VA
212RA238
flywheel.
Degrease crankshaft stub and bore
in flywheel hub with standard
solvent-based degreasant
containing no chlorinated or
halogenated hydrocarbons – b 16.
Reassemble in the reverse
sequence.
: Make sure that machined key
(arrow) engages the slot in the
crankshaft.
VA
212RA237
– Adjust air gap between ignition
module and flywheel – b 7.1.2
Assemble all other parts in the
reverse sequence.
– Remove carburetor – b 12.2.1
– Remove the switch shaft –
b 10.1
: Pull the ground wire (1) off the
contact spring (2).
VA
212RA122
2
1
: Carefully pry the contact spring
(1) sideways and out of the
housing.
Reassemble in the reverse
sequence.
VA
212RA123
1
: When installing, make sure the
contact spring is under the pin (1)
and between the stop lugs
(arrows).
VA
212RA124
1
7.2 Contact Spring