Online version - not for reprint
53MS 341, MS 361, MS 361 C
– Coat inside of spark plug boot
with PressFluid OH 723.
: Push the ignition lead and leg
spring into the spark plug boot.
212RA292
VA
: Make sure the leg spring locates
properly inside the spark plug
boot.
– Fit the cover over the spark plug
boot.
VA
176RA161
: Use a pointed tool to pierce the
center of the other end of the
ignition lead.
VA
176RA162
– Slip the insulating tube and
grommet over the ignition lead.
– Pack the high voltage output with
STIHL multipurpose grease –
b 16.
Do not use either graphite grease or
silicone insulating paste.
– Screw the ignition lead into the
ignition module.
– Push the grommet over the high
voltage output.
– Install the ignition module –
b 7.1.2
– Remove the fan housing with
rewind starter – b 8.2
– Block the piston with the locking
strip – b 5.4
: Unscrew the flywheel nut (arrow).
VA
212RA233
: Mount the puller (1)
1135 890 4500 to the flywheel
with screws (2).
: Screw home thrust bolt (3) until
the flywheel is released.
VA
212RA234
3
1
2
7.1.5 Flywheel
To Next Page
Loading...
