Stihl MS 341 - Saw Chain Sharpening Techniques; Proper Sharpening Procedure; File Holder and Guide Technique

Online version - not for reprint
86 MS 341, MS 361, MS 361 C
– Remove carburetor – b 12.2.1
– Remove pickup body – b 12.7
: Pull the fuel hose out of the
retainer (arrow).
VA
212RA180
: Pry the flange of the fuel hose out
of the fuel tank.
– Pull out the fuel hose.
Install in the reverse sequence.
When installing, make sure the flat
VA
212RA181
side of the fuel hose points towards
the cylinder.
– Drain the fuel tank.
– Drain the oil tank.
Collect fuels and lubricants in clean
containers or dispose of properly in
accordances with regulations.
– Remove the shroud – b 6.2
– Remove the carburetor –
b 12.2.1
– Disconnect the short circuit wire
and ground wire from the ignition
module – b 7.1.2
On machines with handle heating
and/or carburetor heating
– Remove the ignition module –
b 7.1.2
: Pull connector (1) out of guide
(arrow) and disconnect.
VA
212RA184
1
: Pry the grommet (1) out of its
seat and push the wires (2)
inwards.
VA
212RA185
1 2
On machines with handle heating
and/or carburetor heating
: Take out the screw (1).
: Remove the wire (2).
212RA187
1
VA
2
: Take the sleeve (1) out of
the manifold and pull off the
washer (2).
VA
212RA056
1
2
12.8 Fuel Hose 12.9 Separating Crankcase
and Tank Housing