To Next Page

To Previous Page

Online version - not for reprint

72 MS 341, MS 361, MS 361 C

: Pull the suction hose (1) with

pickup body (2) out of the

crankcase.

212RA139

: Pull the pickup body (1) off the

suction hose (2).

Reassemble in the reverse

sequence.

212RA141

– Insert the suction hose in the

crankcase.

– Lubricate grommet with a little oil.

: Use a blunt tool to push the

suction hose into the crankcase

so that the tab locates in its seat

212RA140

at the bottom right (arrow).

Reassemble all other parts in the

reverse sequence.

A valve is installed in the tank wall to

keep internal tank pressure equal to

atmospheric pressure.

– Remove the oil tank cap.

– Drain the oil tank.

Collect chain oil in a clean container

or dispose of it properly at an

approved disposal site.

– Remove the inner side plate –

b 5.5.1 or 5.5.2.

: Blow the valve (1) clear with

compressed air (from outside to

inside of tank).

– Flush out the oil tank.

Reassemble in the reverse

sequence.

212RA142

11.2 Valve

11.2.1 Cleaning

Stihl MS 341 Shop Manual

Other manuals for Stihl MS 341