Stihl MS 341 - Guide to Using Manual and General Safety; General Safety Rules

Online version - not for reprint
101MS 341, MS 361, MS 361 C
– If necessary, remove the front
handle with handle heating –
b 14.5
– If necessary, remove the heater
switch – b 14.6
Install in the reverse sequence.
: Position the wires (1) under the
switch shaft (2).
On machines with
QuickStop Super
VA
212RA246
1
2
: Position the wires (arrows) under
the brake cable (1).
VA
212RA240
1
: Make sure the ground wire (1)
and short circuit wire (2) are
correctly positioned (see arrows).
Install all other parts in the reverse
sequence.
212RA308
VA
1
2
– Separate the crankcase from the
tank housing – b 12.9
– Remove the short circuit wire –
b 10.1
– Remove the ground wire – b 7.2
VA
1
2
212RA242
: Pull wires with connectors (1 + 2)
out of the retainers (arrows).
– Separate the connectors and
remove the heating elements.
: Take the suction hose (1) out of
the guide.
: Pull the wires (2) forwards and
out of the guide.
VA
212RA243
2
1
14.8.3 With Handle and
Carburetor Heating
System