STONEX R2W PLUS 500

To Next Page

To Previous Page

R2W PLUS

⑦After instrument is

established in P1,enter into

traverse surveying of

coordinate measurement and

select “Call” button with

stylus.

※1)

⑧Collimate last occupied

point P0. Click “Setup” key,

then coordinate of P1 and

azimuth angle from P1 to P0

will be ascertained. And it

returns to main menu at the

same time.

⑨Repeat steps①～ ⑧， and

carry on according to the

sequence of guidelines till

the end.

※1) Click “Exit” key to finish Traverse Surveying.

STONEX R2W PLUS 500 - Page 66