STONEX R2W PLUS 500 - Page 75

R2W PLUS
66
③Collimate prism P2, and
click “Measure” key.
【Measure】
④Collimate prism P3, and
click “Measure” key.
【Measure】
⑤Click “Continue” key to
calculate relational values
between collimation axis
and plane.
※1)
【Continue】
※1)Click “Setup” key to set instrument height and prism height.
●If the three observing points can’t determine a plane, the system will display error
message. Thus observe the first point once again.
●When collimation axis doesn’t intersect with determined plane, the system will display
error message.