17
03.11
Strapex SMA 30
CAUTION!
Used where there is dan-
ger to life and health.
WARNING!
Used for danger which
can cause material
damage.
NOTE!
Used for general infor-
mation and information
which if not followed can
cause faults in the
operating sequence.
2 GENERAL INFORMATION
These operating instructions are intended to simplify
familiarisation with the machine and the ways in which
it may be used for the intended purpose. The operat-
ing instructions contain important information concern-
ing the safe, proper and effi cient use of the machine.
Compliance with the instructions will help to avoid
danger, reduce repairs and stoppages and increase
the reliability and service life of the machine.
The operating instructions must always be available
at the place of operation of the machine. They must
be read and observed by all persons concerned with
work on the machine. This work specifi cally includes
operation, refi lling of operating material, fault elimina-
tion and maintenance.
In addition to the operating instructions and the regu-
lations for accident prevention effective in the country
of use and place of application, the recognised tech-
nical regulations for safety and proper working must
also be observed.
3 MODES OF OPERATION
A difference is drawn between normal and special
operation:
– Normal operation
The machine is in normal operation when the
package is strapped without fault. These tasks are
described in chapter 6 and 7.
For normal operation it is assumed that the machine is
correctly connected to the mains and switched on and
the strap is correctly inserted.
– Special operation
The machine is in special operation when it cannot
comply with normal operation conditions. This is the
case when changing the strap coil and during fault
elimination, cleaning and maintenance (chapter 8
and 9).
DECLARATION OF CONFORMITY
We take sole responsibility for declaring that the
machine SMA 30, to which this declaration refers,
is in full compliance with the current requirements
of the guidelines laid down by the council on 17th
May 2006 (2006/42/EEC) “Machine Guidelines“.
Furthermore, electrical installations are in compli-
ance with the guideline laid down by the council on
12. December 2006 (2006/95/EEC) “Low Voltage
Guidelines“ and from 15. December 2004
(2004/108/EEC) “EMV Guidelines“.
According to norm:
EN ISO 12100-1, EN ISO 12100-2, EN 349,
EN ISO 13857, EN ISO 13850, EN 61000-6-2,
EN 61000-6-3, EN 50371, EN 415-8
EEC-Design certifi cation: ED/2005/70061-1
Place of certifi cation: 134, Wu Kung Road, Taipei,
Taiwan. SGS Taiwan Ltd.
MD Services
CH-8953 Dietikon, 18.12.2009
General Manager Manager Products
Technology: Packaging Technology:
U. Schweizer M. Binder
Authorized person for the publication of technical documentation:
M. Stutz, ORGAPACK GmbH, Silbernstr. 14, 8953 Dietikon
To Next Page
Loading...
