Basic Setup Welcome Kit Contents
Page 9
© Copyright 2022 Stratasys. All rights reserved.
Basic Setup
Follow the Site Preparation Guide to ensure that your facility is effectively and safely prepared
for printer installation. Do not proceed with the following sections until the “Unpacking the
Printer” section of the Site Preparation Guide has been completed. When installation is
complete, perform the following setup tasks.
Table 2: Accessories
# Item Description
1 Resin Tray
The resin tray will contain the resin used to print parts. It is used to secure the tray sheet
which is instrumental in releasing cured layers.
2
Build
Platform
(2x)
The build platform is the substrate on which the printed model will be attached and anchored
during the build process.
3 Tubing 570mm tube for pump tubing replacement. See Chapter 6 Maintenance (page 51).
4
Fan Filters
(4x)
Replacement fan filters. See Chapter 6 Maintenance (page 51).
5
Linear Drive
Grease Kit
3ml syringe, grease, and tip cover for lubricating the z linear drive. See Chapter 6
Maintenance (page 51).
6
Torque
Driver, 4Nm
4mm
Torque driver set to 4Nm use to secure the tray sheet to the resin tray. See Chapter 6
Maintenance (page 51).
7
Torque
Driver,10Nm
5mm
Torque driver used to calibrate the build platform. See Chapter 5 Operating the Printer
(page 25).
8
Cable, Main
Power
Power cable used to provide power from the wall receptacle to the printer.
9
Cable,
Ethernet
Used to connect the printer to the Origin Cloud App.
10
Door
Latches (2x)
Attach (with included allen screws) to the door to ensure the printer cannot be inadvertently
opened while in use..
To Next Page
Loading...
