Regulatory and Environmental Information Canada Electromagnetic compatibility (EMC)
Page 79
© Copyright 2022 Stratasys. All rights reserved.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Canada Electromagnetic compatibility (EMC)
Normes de Sécurité (Canada)
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de Classe A prescrites dans le réglement sur le
brouillage radioélectrique édicté par le Ministère des Communications du Canada.
DOC Statement (Canada)
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications.
MSDS (Material Safety Data Sheet)
You can obtain current Material Safety Data Sheets for printer materials from the Stratasys
website at: http://www.stratasys.com/materials/material-safety-data-sheets.
Caution:
Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this
equipment not expressly approved by Stratasys, ltd. may cause harmful interference
and void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a commercial
environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at their own expense.
To Next Page
Loading...
