Tray Maintenance Replacing Tray Sheets
Page 57
© Copyright 2022 Stratasys. All rights reserved.
Required Tools
• Nitrile goloves
• 4mm hex 4Nm T-handle driver
• Resin tray thumbscrew
Procedure
1. Using a 4mm hex 4Nm T-handle driver, remove 8 screws from the bottom of the tray.
Figure 6: Tray and tools
Warning: Skin contact hazard
Prolonged contact with solvents can cause skin irritation. Do not continue before
putting on protective gloves.
To Next Page
Loading...
