Strobel KA-ED - General machine information; Operating instructions

7 BA_KA-ED_A22_190313_en.doc
2 General
2.1 Operating instructions
Any person involved in the installation, operation, maintenance and repair of the
machine must have read and understood the operating instructions and in particular
the safety instructions before starting the machine.
2.2 Class identification, serial number and orientation of the
machine
The operating side of the machine is the basis for orientation for descriptions referring
to sides.
The class identification (type) is located on the right hand side of the machine stand;
the serial and model number (after the dash) are stamped into the base plate's front
surface on the back as well as on the type sign on the back side of the machine stand.
2.3 Intended use of the machine
For automatic roll padding of right and left lapels, completely mirrored and not
warped.
The Strobel roll padder consists of a left and a right machine. Both machines operate
independently from each other.
The longest possible stitch length at the lapel roll line is 58 cm, the shortest stitch at
the lapel tip is about 3 cm.
The shape of the lapel can be user-defined. The edges are scanned automatically by
light barriers.
The edge distance at stitch start (10 mm – 25 mm) and at the stitch end
(10 mm – 50 mm) can be freely set.
The distance between the seams can also be freely set up to about 16 mm.