Strobel KA-ED - Default Chapter; Table of Contents

1 BA_KA-ED_A22_190313_en.doc
TABLE OF CONTENTS
1
General notes on safety ............................................................................................................. 5
2 General ....................................................................................................................................... 7
2.1 Operating instructions ...................................................................................................... 7
2.2 Class identification, serial number and orientation of the machine................................ 7
2.3 Intended use of the machine ............................................................................................ 7
2.4 Technical data of the machine .......................................................................................... 8
3 Installation and commissioning ................................................................................................ 10
3.1 Lubrication (Fig. 2) .......................................................................................................... 11
3.2 Transit support ................................................................................................................ 11
3.3 Direction of rotation of the machine .............................................................................. 11
3.4 Motor drive by tooth-belts ............................................................................................. 12
3.4.1 Tension of the tooth-belt (Fig. 3) ..................................................................... 12
3.4.2 Checking the tooth-belt for the carriage drive ................................................. 13
3.4.3 Positions of the machine .................................................................................. 14
3.5 Pneumatic connection .................................................................................................... 16
3.6 Power supply ................................................................................................................... 16
3.7 Check light barriers ......................................................................................................... 16
4 Notes on use and maintenance ............................................................................................... 17
4.1 Needles and threads ....................................................................................................... 17
4.2 Inserting the needle (Fig. 7) ............................................................................................ 17
4.3 Thread monitor ............................................................................................................... 18
4.4 Threading (Fig. 8a + b) .................................................................................................... 19
4.5 Operating element in the distribution box ..................................................................... 19
4.5.1 Main switch S0 (Fig. 9) ...................................................................................... 20
4.6 Operating elements in the switch box ............................................................................ 20
4.6.1 START button S4 (Fig. 10) ............................................................................. 20
4.6.2 STOP button S5 (Fig. 10) ............................................................................... 21
4.6.3 Toggle switch S6 (Fig. 10) .................................................................................. 21
4.6.4 Light L2 (yellow) (Fig. 10) .................................................................................. 21
4.6.5 Button “1” on the V810 operating control (Fig. 10) ......................................... 22
4.6.6 Button “2” on the V810 operating control (Fig. 10) ......................................... 22
4.6.7 Button “3” on the V810 operating control (Fig. 10) ......................................... 22
4.6.8 Button “4” on the V810 operating control (Fig. 10) ......................................... 22
4.7 Inserting the sewing material (Fig. 11 + Fig. 16b) ........................................................... 23
4.8 Setting the stitch depth (Fig. 10 + Fig. 12a) .................................................................... 24
4.9 Digital stitch depth display (Fig. 10) ............................................................................... 25
4.10 Setting the seam distance (Fig. 13) ................................................................................. 25
4.11 Setting the stitch length (Fig. 12b) ................................................................................. 26
4.12 Finetuning the upper transport (Fig. 14) ........................................................................ 27