59 BA_KA-ED_A22_190313_en.doc
Transport in stitch direction insufficient
Possible reasons:
- The stitch length is set too short.
- The carriage speed is set too low.
- The feed dog is set too high.
- The transport support pressure is too low.
Solutions:
- Increase the stitch length with stitch setting knob 144.0156.
(see Spare parts catalogue page 26 bzw. 30)
- Change the carriage speed see point “4.6.7. Button “3” on the V810
operating control“.
- Loosen the screws 172.0502 and set the feed dog 182.0054/182.0094
lower.
(see Spare parts catalogue page 28 bzw. 32)
- Increase the transport support pressure by turning the screw 174.0433
clockwise.
(see Spare parts catalogue page 38)
To Next Page
Loading...
