AbraPol-10
Instruction Manual
57
Message Explanation Action
START denied method not selected A method has not been select. Select a method and press start.
Manual dosing denied method step
not selected
Manual dosing has been denied
because step has not been
selected.
Choose a preparation step that
contains the suspension or lubricant
in question.
The following lubricant is not
configured: " xx "
The lubricant chosen for a certain
preparation has not been
configured and the preparation can
not proceed.
In the CONFIGURATION MENU it
is possible change the set-op for
the different lubricants.
(See Setup Bottle Configuration)
You can not dose with water The manual lubricant key has been
pressed in a step where water was
selected.
Use the
w
key for manual dosing
of water.
Process time or stock removal not
specified (zero)
The step can not start because
neither time nor removal have been
specified.
In EDIT METOD STEP specify time
or stock removal.
START denied, selected method or
step is Empty
It is not possible to start a
preparation process from an empty
method or step.
Chose a method or a step which is
not empty before pressing start.
Tube(s) not selected for cleaning
push knob to select tube(s)”
The tube has not been selected and
can therefore not be cleaned.
Push knob to toggle between yes
and no in the select column – yes
must be selected if you want to
clean the tube.
The following abrasive is not
configured: " xx "
The abrasive chosen for a certain
preparation has not been
configured and the preparation can
not proceed.
In the CONFIGURATION MENU it
is possible change the set-op for
the different abrasives.
(See Setup Bottle Configuration)
Method name already in use,
please rename the method
A method name can only be used
once.
Use a different name.
To Next Page
Loading...
