EN-22
DRAFT
Note: When using small-joint handpieces, only Default 2 settings are
available. No other defaults or user preferences can be applied.
Adjusting Cutting Speed
Use the
buttons on the console to manually adjust the power or
speed setting for the active handpiece.
Note: In shaver mode, the console uses radio frequency identication (rfid) to
automatically detect which type of disposable attachment is connected to the
handpiece. Upon recognition, the console adjusts to an optimal preset cutting
speed, direction, and power.
Note: Forward and reverse settings are adjusted independent of each other.
Adjusting settings in one mode will not aect the other.
To Next Page
Loading...
Need help?
General
