44..55..22.. TToo RReemmoovvee PPoowweerr aanndd RReellooccaattee tthhee RRoovveerr
NNoottee -- Always use the rover handle when repositioning or relocating the rover.
NNoottee -- If the rover is full or the rover will not be used for two hours, dock the rover to dispose of the collected fluid waste
in the canister.
NNoottee -- The rover is not required to be connected to facility power when not in use.
1. Push the power switch to the OFF position (Figure 38).
2. Disconnect the power cord from facility electrical power. Wrap the power cord around the cord bracket.
3. Unlock the casters of the rover. Make sure all four casters are unlocked.
FFiigguurree 3388 –– RReemmoovvee tthhee PPoowweerr
4. If the canister is full or the rover contains fluid waste and will not be used within two hours, relocate the rover to the
docker using the rover handle. See
To Dock the Rover
(page 54).
5. If the canister is not full and the rover will be used within two hours, relocate the rover to the desired location using the
rover handle. See
To Setup the Rover
(page 36).
6. Clean and disinfect the rover after every surgical procedure. See
To Clean and Disinfect the Rover
(page 50).
700000969828 Rev-AA 49 EN
To Next Page
Loading...
Need help?
General
