Stryker Performance-PRO XT - Vehicle Safety Hook Selection

3. Flip the cot upside down on the two saw horses.
4. Using a 3/8” and 7/16” combination wrench, remove all four caster mount bolts (C) that secure the outer lift tube
assemblies to the foot base tubes (Figure 10).
C
FFiigguurree 1100 –– RReemmoovvee tthhee ccaasstteerr mmoouunntt bboollttss
5. Using two 9/16” combination wrenches and a dead blow hammer, remove the base connecting rod (D) and centerlock
hex jam nut (E).
NNoottee -- Save the bearings (F) that fall out (Figure 11).
D
E
F
FFiigguurree 1111 –– SSaavvee tthhee bbeeaarriinnggss
6. Remove the outer base tube weldment (G) on the side that is damaged. Leave the opposite side on to support the X-
frame (Figure 12).
7. Slide the foot base tubes (H) through the X-frame legs to loosen the X-frame (Figure 12).
NNoottee -- The opposite side will still have the outer base tube and foot base tubes attached to the X-frame.
8. Remove the inner tube and save the bushings (J) to reuse on the new tube (Figure 12).
6086-009-002 Rev AB.2 17 EN