NNoottee -- Make sure that the X-frame guard screw hole on the new inner tube is facing the top of the cot when
reassembling.
13.Verify proper operation before you return the product to service.
SSiiddeerraaiill aasssseemmbbllyy rreeppllaacceemmeenntt ((ssttaannddaarrdd))
TToooollss rreeqquuiirreedd::
• T25 Torx driver
PPrroocceedduurree::
1. Raise the product to the highest height position.
2. Raise the siderail to the up and locked position.
3. Using a T25 Torx driver, remove the three spindle screws that secure the siderail assembly.
4. Remove the siderail.
5. Reverse steps to install the new siderail assembly.
6. Verify proper operation before you return the product to service.
SSiiddeerraaiill aasssseemmbbllyy rreeppllaacceemmeenntt ((XXPPSS ooppttiioonn))
TToooollss rreeqquuiirreedd::
• T25 Torx driver
• 1/4'' hex wrench
• 3/16'' hex wrench
• Slotted screwdriver
• Torque wrench (ft-lb)
• Rubber mallet
PPrroocceedduurree::
1. Raise the product to the highest height position.
2. Remove the mattress.
3. Using a T25 Torx driver, remove the button head cap screw (A) and black bumper (B) on the side where you are
replacing the siderail (Figure 15). Save the screw and bumper.
6086-009-002 Rev AB.2 21 EN
To Next Page
Loading...
Need help?
General
