Stryker ProCuity Series User Manual

3. Press the NNuurrssee ccaallll button (B) to verify the connection between the product’s nurse call signal and the hospital’s nurse
call system (
Operator control panel, basic, outside siderail (page 24), Operator control panel, advanced, outside siderail
(option)
(page 25)).
To activate nurse call communication, see
Activating nurse call (page 23).
FFiigguurree 44 –– 3377--ppiinn ccoonnnneeccttoorr
SSeettttiinngg uupp ii BBeedd WWiirreelleessss ((ooppttiioonn))
WWAARRNNIINNGG -- Always map the ii BBeedd LLooccaattoorr or SSeeccuurree CCoonnnneecctt to the location to provide location information. If you move
an
ii BBeedd LLooccaattoorr or SSeeccuurree CCoonnnneecctt after it has been set up and mapped, you must remap to the new location.
To setup your product to receive a wireless connection, you must set up the
ii BBeedd LLooccaattoorr™ or SSeeccuurree CCoonnnneecctt on the
wall at the head end of the product. The
ii BBeedd LLooccaattoorr or SSeeccuurree CCoonnnneecctt communicates with the product. For instructions
about how to mount the
ii BBeedd LLooccaattoorr or SSeeccuurree CCoonnnneecctt, see the ii BBeedd LLooccaattoorr Installation Manual or SSeeccuurree CCoonnnneecctt
Installation/Configuration Manual.
Contact Stryker Technical Support at (800) 327-0770 with any set up questions.
NNoottee -- You must load the wireless connection settings before the device will communicate with the
ii BBeedd Server application.
See the
ii BBeedd Server Installation/Configuration Manual.
SSeettttiinngg uupp wwiirreelleessss nnuurrssee ccaallll ccoommmmuunniiccaattiioonn ((ooppttiioonn))
When paired with SSeeccuurree CCoonnnneecctt the product can send a wireless nurse call signal. This setup will be performed by
authorized personnel before the product is placed into service.
To test wireless nurse call communication:
1. Apply the brakes (
Applying or releasing the brakes (page 18)).
NNoottee -- Apply the brakes for SSeeccuurree CCoonnnneecctt and the product to establish a first connection.
2. Press the NNuurrssee ccaallll button (B) to verify the connection between the product’s nurse call signal and the hospital’s nurse
call system (
Operator control panel, basic, outside siderail (page 24), Operator control panel, advanced, outside siderail
(option)
(page 25)).
To activate nurse call communication, see
Activating nurse call (page 23).
3009-009-001 Rev B.0 15 EN

Stryker ProCuity Series Specifications

General

Bed Type	Hospital Bed
Weight Capacity	500 lbs (227 kg)
Integrated Scale	Yes
Bed Exit System	Yes
Side Rail Controls	Yes
Category	Medical Equipment
Monitoring Parameters	Weight, bed exit
Display	Touchscreen
Alarms	Bed Exit, Low Battery