Stryker ProCuity Series User Manual

To charge the battery, connect the product to a hospital grade protective earthed outlet. The battery has a full charge within
eight hours.
SSttoorriinngg tthhee ppoowweerr ccoorrdd
WWAARRNNIINNGG
• Always store the power cord before you transport the product.
• Always store the power cord to avoid the risk of entanglement, damage to the power cord, or potential shock hazards. If
the power cord is damaged, remove the product from service.
CCAAUUTTIIOONN -- Do not pinch the power cord in the bed frame.
To store the power cord and auxiliary cord, wrap the cords and secure them with the cord wrap under the head end of the
product.
TTrraannssppoorrttiinngg tthhee pprroodduucctt
WWAARRNNIINNGG
• Always use two people when you transport the product.
• Always store the power cord before you transport the product.
• Always lock the siderails in the full up position with the sleep surface horizontal when you transport a patient.
• Always keep limbs, hands, fingers, and other body parts clear of mechanisms and gaps.
• Always check that there are no obstacles near the product. Injury to the patient, operator, bystanders or damage to the
frame or surrounding equipment could occur if you collide with an obstacle.
• Do not attempt to transport the product laterally. This may cause the product to tip.
CCAAUUTTIIOONN
• Do not use the siderails as a push or pull device. Always move the product using the integrated handles in the
headboard and footboard.
• Always remove the patient helper before you transport the product.
• Do not use the patient helper as a push or pull device.
• Do not use the oxygen bottle holder as a push or pull device.
• Do not use the IV pole as a push or pull device.
• Always make sure that the IV pole is at a low height during transport.
To transport the product:
1. Lock the siderail control panel functions (
Footboard control panel - Motion lock (page 31)).
2. Unplug the power cord from the wall outlet.
3. See
Storing the power cord (page 17).
4. Lower the IV pole (
Raising or lowering the IV pole (option) (page 38)).
5. Turn the oxygen bottle holder in toward the product.
6. Raise and lock the siderails in the full up position (
Raising the siderails (page 20)).
7. Release the brakes (
Applying or releasing the brakes (page 18)).
8. Push the product from the headboard or footboard.
3009-009-001 Rev B.0 17 EN

Stryker ProCuity Series Specifications

General

Bed Type	Hospital Bed
Weight Capacity	500 lbs (227 kg)
Integrated Scale	Yes
Bed Exit System	Yes
Side Rail Controls	Yes
Category	Medical Equipment
Monitoring Parameters	Weight, bed exit
Display	Touchscreen
Alarms	Bed Exit, Low Battery