Strymon DIG - MIDI Functionality; Configuring DIG to Use MIDI

pg 28
DIG - dual digital delay
MIDI Functionality
Configuring DIG to Use MIDI
Using MIDI unlocks a set of tools that can be used to load any of DIG’s
300 preset locations using a suitable MIDI controller or interface con-
nected to the DIG EXP/MIDI jack� This requires a Strymon MIDI EXP
cable or a MIDI controller/interface, such as Strymon Conduit, with at
least one quarter-inch output�
NOTE: When using a Strymon MIDI EXP Cable, the MIDI OUT mode must be
set to Off� (See page 32 for more info�)
Please see strymon�net/support/dig-v2 for a list of compatible devices�
MIDI Enabled Stompbox
MIDI Controller with
5-pin MIDI Outputs
MIDI Controller with
1/4" TRS Output
1/4" TRS
MIDI Interface
(such as Strymon Conduit)
OR
MIDI EXP cable TRS cable
OR