pg 30
DIG - dual digital delay
Configuring DIG to Use MIDI (cont�)
STEP 2 – SET MIDI CHANNEL
3 Turn the TIME knob to set the MIDI communication channel� The
TAP LED indicates status� Your TIME knob selections are as follows:
• Channel 1: GREEN (default)
• Channel 2: AMBER
• Channel 3: RED
• Channel 4-16: BLUE (set by next received MIDI Program Change
message, requires 1⁄4" MIDI connection)
Once the TAP LED turns BLUE, it will blink until the pedal receives
a MIDI Program Change message� Once a message is received, the
pedal will be set to the MIDI channel that carried the message and
exit the power-up mode to allow you to begin using DIG�
To Next Page
Loading...
