Stuart SMP50 - Page 51

To Next Page

To Previous Page

Select the result of the first calibration standard

❖ Choose the result file for calibration by selecting and touching on it.

Choose a result for calibration

The mean clear point of the selected result will automatically populate the display for ‘First measured

temperature’.

Main Page

Default Chapter2
- Table of Contents2
1 Introduction4
2 Safety Advice before Use4
3 General Description4
4 Preparation for Use5
- Electrical Installation5
- Installation6
- Warning6
5 Instrument and Software Controls7
- Instrument7
- Connecting the Accessory Printer7
6 Melting Point Determination8
- Terminology8
- Temperature Settings8
- Sample Preparation9
7 Operation9
- Power up9
- Main Menu Screen10
- Navigation Bar11
8 Settings11
- Changing the Settings12
9 Creating a User Account13
10 Setting up a New Measurement15
- More Options16
- Add Measurement Protection17
11 Running a Melting Point Determination18
- Sample Preparation18
- Tips on Running a Melting Point Determination18
- Starting a Measurement19
- Viewing a Measurement in Progress20
- Aborting a Measurement23
12 Performing a Rapid Melt23
13 Viewing Melt Reports and Videos24
- Manual Event Tagging25
- Opening Previously Saved Melt Reports27
- Deleting or Copying a Melt Report28
14 Managing Measurement Files29
- File Display30
- Searching Measurement Files32
- Favourites34
- Copying and Deleting Measurement Files35
- Editing Measurements38
15 Managing Results Files39
- File Display39
- Searching Results Files41
- Favourites42
- Copying and Deleting Results Files43
- Viewing Results Files on a Computer46
- Viewing Encrypted Results Files46
16 Printing Results47
17 Instrument Calibration49
- Calibration Procedure49
- Calibration Correction Factor54
18 Performing a Software Update55
19 Maintenance and Servicing56
- Fuse Replacement56
- Repairs and Support56
- Cleaning the Sample Block57
20 Warranty58
21 Specification58
22 Accessories58
23 Declaration of Conformity59

Stuart SMP50 - Page 51

Table of Contents