34
Freq：ranges from 20 Hz to 200 Hz, with a default @ 100 Hz. Adjust the Frequency by
turning the main encoder or on the touch screen (fine tuning can be activated by pressing
the main encoder knob). Double press the parameter frame to set it as default.
⑤ EQ HS
Curve: displays the HS curve
Gain：ranges is ±18 dB, with a default @ 0 dB. Adjust the Gain by turning the main encoder
or on the touch screen (fine tuning can be activated by pressing the main encoder knob).
Double press the parameter frame to set it as default.
Freq：ranges from 1.5 KHz to 15 KHz, with a default @ 6.3 KHz. Adjust the Frequency by
turning the main encoder or on the touch screen (fine tuning can be activated by pressing
the main encoder knob). Double press the parameter frame to set it as default.
⑥ Other parameters
Speed：ranges from 50 to 200, with a default @ 100. Adjust the Speed by dragging the
slider, or turning the main encoder on the control panel (fine tuning can be activated by
pressing the main encoder knob).
Intensity：ranges from 50 to 200, with a default @ 100. Adjust the Intensity by turning the
main encoder or on the touch screen (fine tuning can be activated by pressing the main
encoder knob).
Pre Delay：configure time of Pre Delay, ranges from 0~100ms, with a default @ 0ms. Adjust
the time parameter by turning the main encoder or on the touch screen
Delay Subpage
Single press “Delay1 or 2” button in the FX Subpage to access the Delay parameter
Subpage shown below.
To Next Page
Loading...
