37
Reverb Subpage
Single press “Reverb1 or 2” button in the FX Subpage to access the Reverb parameter
Subpage shown below.
① Module Selection
Single press the left right selection button, to choose FX module（Modul1-Modul2-Delay1-
Delay2-Reverb1-
Reverb2-GEQ1-GEQ2）。
② Typ e
Single press the dropdown button, then choose a wanted reverb from the dropdown list—
—Hall Bright/Hall Warm/ Room Bright/ Room Warm /Plate Bright/ Plate Warm。
③ Dry-Wet
Ranges from 0 to 100 with a default @ 0. Adjust the parameter of Dry-Wet by dragging the
slider, or turning the main encoder on the control panel.
④ EQ LS
Curve chart: displays the LS curve
Gain：ranges is ±18 dB, with a default @ 0 dB. Adjust the Gain by turning the main encoder
or on the touch screen (fine tuning can be activated by pressing the main encoder knob).
Double press the parameter frame to set it as default.
1 2
3 4 5
6
To Next Page
Loading...
