25
Reverb Times
Min Max Default
Hall 0.8 s 12.0 s 1.6 s
Room 0.4 s 8.0 s 0.8 s
Plate 0.4 s 6.0 s 0.6 s
③ Reverb Time Trim
This fader allows you to trim the available reverb time of the selected reverb type. The
numerical display next to the fader shows the current trim (0%-100%) of the full reverb time.
④ Color
This fader sets the overall tone of the reverb, and the result is displayed as 100 (full treble) to
-100 (full bass). The neutral position is 50.
⑤ Sends to AUX1 and AUX2
These two faders set the overall level of the reverb output being sent to AUX1 and AUX2.
The input mix to the reverb is set by the faders in each input channel’s Bus Send page. Since
these channel sends are not metered you will have to use your ears to ensure that there is
no distortion on the reverb (unless you want some).
⑥ Send to Main Mix
This fader sets the overall level of the reverb output being sent the Main Mix. The input mix to
the reverb is set by the faders in each input channel’s Bus Send page. Since these channel
sends are not metered you will have to use your ears to ensure that there is no distortion on
the reverb (unless you want some).
⑦ Library
The Library function allows you to save and load up to 16 User Reverb presets. Tap the
dropdown button, select a preset from the list and tap OK to load its Reverb settings. Tap the
Save button and select the desired Library Slot (1 – 16) from the list to save the current
Reverb settings. A soft keyboard pop-up will appear on screen, allowing you to name the
preset. Finally press “Confirm” to save the setting or “Cancel” to abandon.
To Next Page
Loading...
