Summa SummaCut D120 - Page 6

SummaCut cutter User’s Manual
Table of contents II
2 Basic Operation.....................................................................................2-1
2.1 LCD AND CONTROL PANEL ...................................................................... 2-1
2.1.1 Control Panel.......................................................................................... 2-2
2.1.1.1 The menu key ....................................................................... 2-2
2.1.1.2 The exit key .......................................................................... 2-2
2.1.1.3 The enter key ........................................................................ 2-2
2.1.1.4 The test key .......................................................................... 2-2
2.1.1.5 The jogging keys , , and ............................ 2-2
2.2 How to Set Tool Parameters....................................................................... 2-3
2.2.1 Setting tool type...................................................................................... 2-3
2.2.2 Changing tool pressure .......................................................................... 2-4
2.2.3 Changing drag knife offset...................................................................... 2-4
2.3 How to Set Cutting Speed........................................................................... 2-6
2.4 How to Change the User (Quick Parameter Change)............................... 2-8
2.5 How to Make Sure the Sign Has the Correct Size .................................... 2-9
3 OPOS (Optical POSitioning).................................................................3-1
3.1 Introduction.................................................................................................. 3-1
3.2 Basic OPOS operation ................................................................................ 3-1
3.2.1 OPOS calibration.................................................................................... 3-2
3.2.2 Media calibration .................................................................................... 3-3
3.3 Detailed OPOS Operation ........................................................................... 3-5
3.3.1 Creating the graphic with the markers.................................................... 3-5
3.3.2 OPOS XY ............................................................................................... 3-8
3.3.3 Printing the graphic................................................................................. 3-9
3.3.4 Loading the graphic into the cutter ....................................................... 3-10
3.3.5 Setting the parameters for the OPOS sensor....................................... 3-10
3.3.6 Registering the markers ....................................................................... 3-12
3.3.7 Cutting the contour ............................................................................... 3-13
3.4 Automating Tasks with OPOS.................................................................. 3-14
3.4.1 Cutting multiple copies of a graphic on the same roll........................... 3-14
3.4.2 Cutting the same graphic on multiple media sheets............................. 3-14
3.4.3 OPOS Barcode..................................................................................... 3-17
3.5 Cutting through ......................................................................................... 3-19