Summa SummaCut D120 - Default Chapter; Table of Contents

To Next Page

To Previous Page

Table of contents I

Table of Contents

1 Setup ......................................................................................................1-1

1.1 Unpacking the Cutter .................................................................................. 1-1

1.1.1 Removing the packaging from the cutter................................................ 1-1

1.1.2 Setting up the machine with a stand....................................................... 1-2

1.1.3 Setting up the machine without a stand.................................................. 1-4

1.2 SummaCut Cutter Components................................................................. 1-5

1.2.1 The Cutter as viewed from the front ....................................................... 1-5

1.2.2 The Cutter as viewed from the back....................................................... 1-7

1.3 Connecting the Cutter to the Mains........................................................... 1-9

1.3.1 Grounding (“Earthing”)............................................................................ 1-9

1.3.2 Operating voltage ................................................................................... 1-9

1.3.3 Powering-on the cutter ......................................................................... 1-10

1.4 Connecting the Cutter to a Computer ..................................................... 1-11

1.4.1 USB connection.................................................................................... 1-11

1.4.1.1 Connecting the SummaCut cutter to a PC using a USB cable...... 1-11

1.4.1.2 Connecting the SummaCut cutter to a Mac using a USB cable .... 1-12

1.4.2 RS-232 Connection .............................................................................. 1-13

1.5 Loading Media ........................................................................................... 1-14

1.5.1 Pinch roller positioning ......................................................................... 1-14

1.5.2 Loading media...................................................................................... 1-15

1.5.3 Media load procedure........................................................................... 1-18

1.6 Tool Installation......................................................................................... 1-20

1.6.1 Knife installation ................................................................................... 1-20

1.6.2 Pen installation ..................................................................................... 1-24

Other manuals for Summa SummaCut D120