Summa SummaCut D120 - Detailed Operation; 4.1 Introduction; 4.2 Main Menu

Detailed Operation 4-1
4 Detailed Operation
4.1 Introduction
This section is a detailed list of all parameters that can be changed and tests that can
be initiated from the control panel.
Section 1 and 2 of this manual describe in detail the most commonly used touch
screen manipulation.
This section may be used as a reference for locating a certain parameter setting or
test. The less frequently used parameters are also explained in this section.
There are two menu’s, the main menu and the system setup menu.
4.2 Main Menu
(1) (2) (3)
FIG 4-1
4-1 MAIN MENU
Menu differs according to the
selected tool
(1) If the PEN is the default tool
(2) If the KNIFE is the default tool
(3) If the POUNCER is the default
tool