SummaCut cutter User’s Manual
Contour Cutting 3-16
NOTE: The second and any following sheets must be loaded in the cutter at the
same position as and with the same orientation of the first sheet. When in OPOS
sheet mode, the cutter stores the distance between edges of the sheet and the
first OPOS marker.
TIP: Use easy orientation points to be able to quickly position the sheet. In the
figure below, a rim of the base plate and the side of the pinch roller assembly are
used to align the sheets.
FIG 3-1
3-1 POSITION MEDIA FRO MULTIPLE SHEET
To Next Page
Loading...
