SummaCut cutter User’s Manual
Detailed Operation 4-7
4.3.8 OptiCut
OptiCut increases the cutting quality in case the knife is worn out or not calibrated
correctly.
Press
, then use or to set OptiCut to ON or OFF. Press to confirm
or
to cancel. OptiCut is default-set to OFF.
4.3.9 Emulate
The SummaCut cutters support DM-PL , HP-GL , HP-GL/2 and Auto.
DM-PL is the recommended plotting language and usually gives the best cutting
quality.
HP-GL emulates an HP 7585B, 7580B, 758X Series HPGL printer.
HP-GL emulates an HP Draftmaster RX / SX / MX 7595B type printer.
Press
, then use or to change the plotting language. Press to
confirm or
to cancel. The default setting is Auto.
4.3.10 USB Class
USB class can be set to Summa USB port 1, Printer Uni (unidirectional), Printer Bidi
(bidirectional), Summa USB port 2, Summa USB port 3, or Summa USB port 4.
Printer Uni and Printer Bidi are for use with printer adaptors with either network or
wireless connection.
Because of the different USB id’s, the computer can make a distinction between
several cutters attached to it (maximum 4).
Press
, then use or to change the USB Class. Press to confirm or
to cancel. The default USB class mode is Summa USB port 1 ( called standard
on older machines - only this setting is compatible with older USB drivers).
NOTE: The minimum USB driver version required for attaching more then 1 cutter to
the same computer is 6.2. The change in USB class becomes active only after
rebooting the cutter.
NOTE: The USB id in the cutting software has to be the same as the chosen USB id
in the cutter. Each time a new USB is select on the cutter and connected for the first
time to the computer, the wizard for installing a driver will be started by Windows.
NOTE: Cutters with firmware revisions lower then 19 do not have the possibility to
assign an id. To a USB port, so only one cutter can be connected to one computer via
USB.
To Next Page
Loading...
