Summa SummaCut D120 - Media; Summacut Media Specifications

SummaCut cutter User’s Manual
Specifications 6-4
6.3.3 Media
D60(SE) D120(SE) D140SE D160SE
mm inch mm inch mm inch mm inch
Width
Roll
70 to 670
2.8 to
26.4
120 to
1270
4.7 to
50.0
180 to
1430
7.1 to
56.3
180 to
1630
7.1 to
64.1
Sheet 70 to 775
2.8 to
30.5
120 to
1375
4.7 to
54.1
180 to
1525
7.1 to
60.0
180 to
1640
7.1 to
64.5
Pinchrollers
2 3 4 4
Max.Cutting/
Plotting area
600 mm
x 50m.
23.6’’x
164 ft.
1200
mm x
50 m
47.2’’ x
164 ft.
1350
mm x
50 m
53.1’’ x
164 ft.
1575 mm
x
50 m
62” x
164 ft.
mm Inch
Minimum
Margins**
25 1
Front margin
18 0.7
Rear margin
Sensor on 42 1.7
Sensor off 25 1
Tracking
performance
8 m/26 feet max. within
guaranteed
specifications*
-8 m/26 feet max. within guaranteed specifications* for media
less than 762 mm (30’’ wide).
-4m/13 feet max. within guaranteed specifications* for media
larger than 762 mm (30’’).
Thickness
0.05 to 0.25 / 0.8mm with optional sandblast knife
0.002 to 0.01 / 0.03 inch with optional sandblast knife
* Media lengths larger than 8 m (26 feet) can be handled, but compliance with specifications is not
guaranteed (will be dependent on media type, media size and other parameters not mentioned here.
** For positioning of the pinch rollers
TABLE 4:
SUMMACUT MEDIA SPECIFICATIONS