SummaCut cutter User’s Manual
Contour Cutting 3-20
The menu can scroll through from flex-cut mode, velocity, full pressure, full
pressure cut-length, flex pressure and flex pressure cut-length.
7. Press
or to change the value of the chosen parameter.
The value will change on the LCD.
8. Press
to confirm.
An asterisk will appear before the value, indicating it is now the selected setting.
Note: Flex-Cut has not be set on if the cutting software can distinguish the
difference between contour cut lines and flex-cut cut lines.
Note: It is difficult to give recommended settings for Flex-Cut. Usually following
start values are used: Flex-Cut mode: Accurate; Full Pressure: 160gr; Full
pressure cut lenght: 10mm; Flex pressure: 80gr; Flex pressure cut length: 0.8mm.
9.
can be pressed at any time during the settings of the parameters to check
the result.
The cutter will cut out a pattern to check if the settings are usable.
10. Check if the result is the satisfactory. If not change one of the parameters above.
Reducing the velocity can also improve the result. It is never recommended to use
cutting speeds larger then 400mm/s (16 ips) with cutting pressures above 170 gr.
Note: It is not always easy to find the correct balance between cutting deep
enough making sure the pieces can be taken out easily, and not cutting too deep
making sure the material keeps it strength while cutting. Sometimes this balance
doesn’t exist meaning that this material can’t be cut through with satisfactory
result.
Note: FlexCut parameters are always metric, regardless the value of the panel
Units parameter (see section on Error! Reference source not found.)
Note: When cutting through, it is recommended that parallel lines are at least 1 cm
away from each other. Otherwise, while cutting the second line, the first line may
come loose and cause trouble.
11. Press to confirm.
12. Press
to leave the menu Flex-Cut menu.
‘Flex Cut’ will appear on the LCD.
13. Use
or to scroll through the menu until ‘Panels’ is reached, press .
‘ON’ or ‘OFF’ will appear on the LCD, depending on whether paneling is already
on or not..
To Next Page
Loading...
