Summa SummaCut D120 - Page 8

SummaCut cutter User’s Manual
Table of contents IV
5 Maintenance and Cleaning ...................................................................5-1
5.1 Introduction.................................................................................................. 5-1
5.1.1 Cleaning the drive system ...................................................................... 5-1
5.1.2 Cleaning the media sensor..................................................................... 5-2
5.1.3 Cleaning the Y-Guide Rail...................................................................... 5-2
5.1.4 Changing the fuse .................................................................................. 5-3
6 Specs and Genaral Information ...........................................................6-1
6.1 Features List ................................................................................................ 6-1
6.1.1 Hardware................................................................................................ 6-1
6.1.2 Interface.................................................................................................. 6-1
6.1.3 Functionality ........................................................................................... 6-1
6.1.4 Software ................................................................................................. 6-1
6.2 CUTTER ACCESSORIES AND CONSUMABLES....................................... 6-2
6.3 Technical Specification............................................................................... 6-3
6.3.1 Machine dimensions............................................................................... 6-3
6.3.2 shipping dimensions............................................................................... 6-3
6.3.3 Media...................................................................................................... 6-4
6.3.4 PERFORMANCE.................................................................................... 6-5
6.3.5 INTERFACE ........................................................................................... 6-5
6.3.6 FIRMWARE............................................................................................ 6-5
6.3.7 ENVIRONMENTAL................................................................................. 6-6
6.3.8 Electrical................................................................................................. 6-6
6.3.9 Certifications........................................................................................... 6-6
6.4 Cutter accessories and consumables....................................................... 6-7