H
HC Residue Check
Pop-up Window 66
See Also Start-up
L
Lambda/AFR Selection, see Gas Analyser
System Settings
Leak Check (Gas), see Maintenance
Leak Check (Vacuum), see Maintenance
Limit Sets 46
Editing in Free Measurement 46
LPG Composition, see Gas Analyser System
Settings
M
Maintenance 10, 52– 71
Check/Install O2 Sensor 59
Filters 63
Gas Analyser Maintenance Menu 20
Gas Calibration Check 58
Leak Check (Gas) 55
Leak Check (Vacuum) 52
Periodic Checks 63
Sample Hose & Probe 64
Test Leads 65
Measurement Procedure 35
Measurements
Accuracy 5
Parameters 5
Range/Resolution 5
N
Negative Indications 30
O
O2 Sensor 59
O2 sensor Check/Install, see
Maintenance
P
Pop-up Window 66
Power 27
Print 24
Sample Printout 25
Vehicle Identification 24
Print Preview 50
Propane Equivalence Factor (P.E.F.) 5
S
Safety Precautions 1
Sample Hose & Probe, see Maintenance
Screen Elements 11
Service Dates, see Gas Analyser System
Information
Setup
Fuel Type Selection 32
Lambda/AFR Selection 32
Shut Down Procedure 36
Speed Factor Selection 32
See also Free Measurement
Vehicle Setup
Standby Mode 18
Start-up
Daily Leak Check Requirement 30
DGA 5000 27
Gas Analyser 27
HC Residue Check 31
Warm up 28
Zero-Calibration 29
Startup 28
Summertime Setting, see Gas Analyser
System Settings
SUN System Error Codes 66
System Status Messages 66
T
Test Leads, see Maintenance
Testing Tips 34
W
Warm-up 67
See Also Start-up 28
Warning Messages 66
Z
Zero Calibration
Pop-up Window 67
Zero-calibration, see Start-up 28
To Next Page
Loading...