126 Sun Fire 280R Server Service Manual • January 2001
c. Connect the main power cable at J0201.
d. Connect the CPU power sense cable at J0205.
e. Connect the keyswitch/power button/LED cable at J0500.
f. Connect the I/O power cable at J0210.
What Next
To reassemble the system, complete the following tasks:
■ “How to Install a PCI Card” on page 61
■ “How to Replace the RSC Card” on page 54
■ “How to Replace the Air Guide” on page 81
■ “How to Replace the Fan Tray Assembly” on page 147
■ “How to Install a Power Supply” on page 142
■ “How to Replace the System Cover” on page 33
■ “How to Place the System Into the Rack” on page 24
About the System Cables
This section provides an overview of cable connector locations and cable routing.
Procedures for removing and replacing cables not covered in this chapter are
included within the removal and replacement process of the assemblies with which
these cables are associated.
In addition, this section provides illustrations depicting connector locations on the
system boards.
To Next Page
