Chapter 2 Servicing the Main Logic Board and Components 77
How to Replace the ID SEEPROM
Module
Before You Begin
Complete this task:
■ “How to Avoid Electrostatic Discharge” on page 35
Note – If you are installing a new ID serially electrically erasable and
programmable read-only memory (SEEPROM) module, it must be programmed by
an authorized Sun service representative before your system can resume normal
operation. If you are installing a new main logic board, remember that you can
migrate your former ID SEEPROM module in order to preserve your system’s host
ID and Ethernet address.
To Next Page
